Electromyography: Bipolar surface EMG electrodes were used to measure signals from the lumbo-sacral erector spinae (LSES), upper lumbar erector spinae (ULES), lower abdominals (LA), biceps femoris and soleus muscle groups. General descriptive (i.e. LSES, ULES, LA) rather than specific (i.e. multifidus, longissimus, transversus abdominus, internal obliques) trunk muscle terminology was used in this paper based on the conflicting findings of similar studies. A number of studies have used a similar L5-S1 electrode placement to measure the EMG activity of the multifidus (Danneels et al., 2001; Hermann and Barnes, 2001; Hodges and Richardson, 1996; Ng et al., 1998). In contrast, Stokes et al., 2003 reported that accurate measurement of the multifidus requires intra-muscular electrodes. Thus, the EMG activity detected by these electrodes in the present study is referred to as LSES muscle activity. Erector spinae muscles according to anatomic nomenclature include both superficial (spinalis, longissimus, iliocostalis) and deep (multifidus) vertebral muscles (Jonsson, 1969; Martini, 2001). The ULES EMG electrode positioning was more lateral than the lower back (LSES) EMG positioning in order to diminish the detection of multifidus activity and thus emphasize the measurement of longissimus activity. Additional electrodes were placed superior to the inguinal ligament and medial to the anterior superior iliac spine (ASIS) for the LA. McGill et al., 1996 reported that surface electrodes adequately represent the EMG amplitude of the deep abdominal muscles within a 15% RMS difference. However, Ng et al., 1998 indicated that electrodes placed medial to the ASIS would receive competing signals from the external obliques and transverse abdominus with the internal obliques. Based on these findings, the EMG signals obtained from this abdominal location are described in the present study as the LA, which would be assumed to include EMG information from both the transverse abdominus and internal obliques. All electrodes were placed collar to collar (approximately 2 cm) on the right side of the body. Skin surfaces for electrode placement were shaved, abraded, and cleansed with alcohol to improve the conductivity of the EMG signal. Electrodes (Kendall® Medi-trace 100 series, Chikopee, MA) were placed 2 cm lateral to L5-S1 spinous processes for the LSES and 6 cm lateral to the L1-L2 spinous processes for the ULES muscles. Additional electrodes were placed superior to the inguinal ligament and 1 cm medial to the anterior superior iliac spine (ASIS) for the LA. Electrodes for the biceps femoris were placed over the mid-belly of the muscle. Soleus electrodes were placed on the mid-line of the muscle directly below the gastrocnemius-soleus intersection. Ground electrodes were placed along the iliac crest for the LSES, ULES and LA, and on the fibular head and lateral malleolus for the biceps femoris and soleus respectively. EMG activity was sampled at 2000 Hz, with a Blackman -61 dB band-pass filter between 10-500 Hz, amplified (Biopac Systems MEC bi-polar differential 100 amplifier, Santa Barbara, CA., input impedance = 2M , common mode rejection ratio ≥ 110 dB min (50/60 Hz), gain x 1000, noise ≥ 5 µV), and analog-to-digitally converted (12 bit) and stored on personal computer (Sona, St. John’s NL) for further analysis. The EMG signal was rectified and smoothed (10 samples) and the amplitude of the root mean square (RMS) EMG signal was calculated during the flexion-relaxation response of the erector spinae using the AcqKnowledge software program (AcqKnowledge III, Biopac System Inc., Holliston, MA). LSES and ULES EMG activity was normalized to a back extension maximum voluntary contraction (MVC). Since all exercises were performed in one session and the comparisons were within subject, a normalization procedure would not be necessary. However, this normalization procedure allowed a comparison of the relative activation of the LSES and ULES during the flexion- relaxation response in this study to other similar studies. Normalization exercises: Subjects were asked to lie prone on a padded table for a maximal exertion back extension exercise. After the investigator palpated the subject’s anterior superior iliac spine (ASIS), the subject was positioned so body segments superior to the ASIS extended off the supporting table. The subject’s lower body was then secured to the table using three straps located just superior to the ankles, knees and gluteal folds. A strap which encircled the subject’s trunk, positioned at the T5 or T6 level maintained the upper body parallel to the floor. A high-tension wire to a metal plate on the floor attached the strap. Trunk Range of Motion (ROM): Hip and trunk flexion range of motion (ROM) was monitored with an electro-goniometer (Biopac Systems TSD 130B Santa Barbara, CA.). One end of the electro-goniometer was taped at the mid-frontal plane of the trunk at the height of the iliac crest. The other end was taped in the mid-frontal plane of the thigh, distal to the greater trochanter of the femur. The pivot point was placed over the greater trochanter of the femur. The starting or reference position was the erect posture of the participant. The signals were amplified (Biopac Systems MEC 100 amplifier, Santa Barbara, CA.), monitored and directed through an analog-digital converter (Biopac MP100) to be stored on the computer (Sona, St. John’s NL). Signals were collected at 2000 Hz, and amplified (1000X). The signal was filtered (1-20 Hz) in order to remove movement artifacts, using the AcqKnowledge software program (AcqKnowledge III, Biopac System Inc., Holliston, MA). Measurements included the initial hip-trunk angle for the onset of EMG flexion-relaxation as well as the range of hip-trunk angles for flexion-relaxation. The period of EMG quiescence signaling the beginning of the flexion-relaxation response was determined to occur when the RMS EMG signal of the LSES or ULES dropped by more than 60% from the mean recorded activity of the experimental trials for that individual prior to the flexion- relaxation response. Similarly, the end of the flexion-relaxation response was noted when EMG activity reoccurred and returned to at least 60% of the mean recorded activity of the pre-flexion- relaxation response for that individual. These two landmarks provided the onset and duration of the flexion-relaxation response. This cut-off standard was determined by analyzing a representative sample of data from each subject (at least one file each for stable and unstable movements). EMG activity during most of the flexion-relaxation period averaged between baseline values and 20% of maximum EMG activity, which corresponds with other studies (Callaghan and Dunk, 2002; Schultz et al., 1985)(see Figures 1-2). LA, biceps femoris and soleus EMG activity reported in the results refers to that activity occurring during the period of erector spinae flexion-relaxation response. Instability-Induced Motion: A tri-axial accelerometer (Silicon Designs, Issaquah, Washington) was mounted on the dorsal region of the trunk, at the L5/S1 level, along the mid-line of the vertebral column. Thus the accelerations in the medio-lateral, cephalo-caudal and anterior- posterior planes, all defined relative to the subject’s trunk segment were measured at a rate of 60Hz. The acceleration-time histories were filtered using a second-order Butterworth routine in order to remove the artifact associated with the flexion-extension movement. These data were then submitted to a fast Fourier transformation in order to determine the power and frequency characteristics of the signal. |