When a shuttlecock is in flight, according to Newton’s Second Law: As a shuttlecock is falling down vertically, the speed and resistance force will increase (Eq. 2). The rate of acceleration becomes zero when the increased resistance force eventually balances the weight. At this point, the shuttlecock reaches its terminal velocity VT and from then on it continues to move with zero acceleration. After this point, the motion of a shuttlecock is under constant velocity. The terminal velocity can be obtained from Eq. (1) and (2) by neglecting buoyancy and setting a = dv/dt = 0. This gives Resistance force could be modeled in two ways, either proportional to object speed or to the speed squared. Assume the shuttlecock is hit with initial velocity v⃗i, then, the horizontal and vertical velocities are expressed by We consider vertical and horizontal directions respectively. (a) Vertical component: and height From Eq. (7), at the top of trajectory, that is, the point of maximum height H, we have vy = 0 , this gives the time of flight (b) Horizontal component: We may integrate Eq. (10) to obtain horizontal velocity and horizontal distance Combine Eq. (8) and (12), then we have the equations of the trajectory as n = 2, consider the air resistance force of the shuttlecock as F⃗v = FvxiÌ‚ + FvyjÌ‚, here Fvx = bv2 cos θ¸ and Fvy = bv2 sin θ¸ are the x - component and y - component of air resistance force, respectively. Obviously, the factor v in each of the force component expressions is the essential coupling between the x and y equations that prevents any analytic solutions from being found. These equations can only be solved satisfactorily accurately using analytical method. But in order to describe the role of terminal velocity and approach the practical trajectory of a shuttlecock, let us consider motion in the vertical and horizontal directions separately. A. Vertical directional motion: in this case After integration, we have the solution of vertical velocity as Where is the terminal velocity. When the shuttlecock reaches the highest point where we have vy = 0, , the time of flight ‘t’ is expressed as follows: At this moment, the height of apex is B. Horizontal direction: here we have and could find the horizontal speed as and horizontal distance as Combine Eq.(17) and (20), we have the equation of the trajectory as Theoretically, the relationship between air resistance and speed was revealed in n and b. At first sight, it seems that to find the trajectory of the shuttlecock, we need to measure n and b in the beginning. However, from the derived results of Eq. (13) or Eq. (21), we have found that the coefficients n and b could be determined by the terminal velocity vt. In other words, if the terminal velocity was measured, the shuttlecock’s trajectory might be found. |